درباره این کالا بیشتر بدانید

ماژول WIFI ESP8266 ESP-01 دارای دو ورودی / خروجی عمومی و پشتیبانی از فرامین AT Comand با جریان مصرفی بسیار پایین مناسب برای کاربردهای IOT

این ماژول جهت فراهم کردن ارتباط بی سیم Wi-Fi به اینترنت یا LAN می باشد و از طریق پروتکل سریال با میکروکنترلر ها ارتباط برقرار می کند. با استفاده از این ماژول می توانید پروژه ی خود را مجهز Wi-Fi کنید.

مشخصات

• ولتاژ کاری:3.3 ولت
• نوع ارتباط با میکروکنترلر: پروتکل سریال UART
• دارای آنتن روبردی
• دو ورودی یا خروجی عمومی GPIO
• تنظیمات از طریق فرامین AT Command
• پشتیبانی از پروتکل های اینترنتی مثل P2P , TCP/IP
• جریان مصرفی پایین
• قابل استفاده با بردهای آردوینو و سایر میکروکنترلر ها

Introduction

This is WiFi serial transceiver module, based on ESP8266 SoC.
The SOC has Integrated TCP/IP protocol stack
We have a set of documents in Chinese. We are preparing tutorials and demo software to showcase utility of this module.
ESP8266 is a highly integrated chip designed for the needs of a new connected world. It offers a complete and self-contained Wi-Fi networking solution, allowing it to either host the application or to offload all Wi-Fi networking functions from another application processor.
ESP8266 has powerful on-board processing and storage capabilities that allow it to be integrated with the sensors and other application specific devices through its GPIOs with minimal development up-front and minimal loading during runtime. Its high degree of on-chip integration allows for minimal external circuitry, and the entire solution, including front-end module, is designed to occupy minimal PCB area.

Specification

802.11 b/g/n
Wi-Fi Direct (P2P), soft-AP
Integrated TCP/IP protocol stack
Integrated TR switch, balun, LNA, power amplifier and matching network
Integrated PLLs, regulators, DCXO and power management units
+19.5dBm output power in 802.11b mode
Power down leakage current of <10uA
Integrated low power 32-bit CPU could be used as application processor
SDIO 1.1/2.0, SPI, UART
STBC, 1×1 MIMO, 2×1 MIMO
A-MPDU & A-MSDU aggregation & 0.4ms guard interval
Wake up and transmit packets in < 2ms
Standby power consumption of < 1.0mW (DTIM3)
SDIO 2.0, SPI, UART
32-pin QFN package
Integrated RF switch, balun, 24dBm PA, DCXO, and PMU
Integrated RISC processor, on-chip memory and external memory interfaces
Integrated MAC/baseband processors
Quality of Service management
I2S interface for high fidelity audio applications
On-chip low-dropout linear regulators for all internal supplies
Proprietary spurious-free clock generation architecture
Integrated WEP, TKIP, AES, and WAPI engines